I love these baby blankets. I was given one for my newborn, and 3 years later its still in heavy use. We keep it in the car for travel. The blankets are big enough to be useful, but because they don't have batting, they still fold up compactly and tuck into a bag. I also take them with me on flights.
There are 2 variations, one with straight edges and rounded corners, or one with scallop edges. I stopped making the scalloped style because it takes twice as long, but I'll still try to explain it here. If I'm not successful, I adapted my pattern from one found in the book "Bend the Rules Sewing" by Amy Karol--pick up a copy for yourself, or visit her blog The Angry Chicken.
1 Yard each of 2 Contrasting Flannel Fabrics
Thread
Salad Plate (To Trace Around)
Remove the pins, turn it right side out, smooth the corners, and iron around the perimeter. Carefully turn the edges under where you left it open, iron and straight pin in place. Now sew around the right sides with contrasting fabric.
Presto, you are done.
If you get 1.3 yards of fabric, you can make some matching burp cloths, cut to a reasonable size, maybe 8" X 15" and use the same sewing methods as the blankets.
To make with scallops (top picture lower right)
1.3 Yards each of 2 Flannel Fabrics. (The Scallops Make the Blanket a Little Smaller.)
30” length of Freezer or Butcher Paper
Salad Plate for Tracing
First trace the plate ¾ of the way around to make the corner, line up the plate tangent to the paper edge. Then move the plate down a bit, line the tangent up with the paper edge and trace 1/3 of the plate, so that the tip of your 1/3 touches the tracing you made at the corner. It should touch the line, but I didn't check the math, so you probably won't be at the edge of the corner plate tracing line. Move the plate down again and trace 1/3. Continue until you're out of paper. You can probably also trace it on the short edge to help line up the pattern on the other edge. Cut around your pattern.
The first blanket I made, I traced ½ of the plate for the scallop. It was still cute, but the scallops were pretty floppy. It's in the top picture, lower left.
Lay out your fabric as I described above, right sides together. Use a water soluble disappearing ink marker to trace the pattern onto the fabric. When you iron with steam, the marks will disappear. Start at one corner and trace the pattern down the side edge, you want to be far enough in that the selvage edge will be cut off. Flip your pattern over to make the next corner and trace pattern toward your initial marks. It probably won't line up perfectly, but that's OK. Just trace it. Then go back and adjust the scallops so that they gradually meet up. No one will notice this. Repeat this process around the other 3 sides. Cut the fabric around your traced lines, and safety pin together.
Sew around the edges close to the edges. Leave a scallop open for turning. After sewing, you can clip the rounded corners so that it turns smoothly. At a minimum, clip the corners where the scallops meet or it will pucker.
Take out the pins and turn the fabric right side out. Push your finger around the inside of each scallop to make sure its fully turned and smooth. Iron around the perimeter. Carefully turn the edges of the open scallop, iron and straight pin. Sew around the perimeter with a contrasting thread color. That's it, you're done.
Skill Level: Easy to Moderate (with scallops)
Time: 1 hour for straight edges, 2 hours for scalloped + 1/2 hour to make the pattern
Cost: $5-$18 depending on fabric source and sales
